1.ON (PUSH TO TALK) button
Sets the microphone sound output.
Press and hold to turn Push To Talk on. The microphone is turned on while pressing the button.
•The indicator on the button indicates the microphone sound output as follows.
—Off: The microphone is off.
—Lights up: The microphone is on.
—Blinks: The microphone talkover is on. When audio is input to the microphone, the volume of all channels other than the microphone channel is attenuated by -24 dB.
2.MIC LEVEL knob
Adjusts the volume of sound input from the [MIC] terminal.
1Connect a microphone to the [MIC] terminal.
2Press the [MIXER SETTINGS] button.
The [MIXER SETTINGS] screen appears.
3Touch [ON] or [OFF] for [Talk Over] to turn Talkover on or off.
4Press the [ON (PUSH TO TALK)] button.
The microphone turns on.
•Press the button again to turn the microphone off.
•Press and hold the [ON (PUSH TO TALK)] button to turn Push To Talk on. The microphone is turned on while pressing the button. Release the button to turn the microphone off.
5Turn the [MIC LEVEL] knob to adjust the microphone volume level.
•Note that turning the knob too far clockwise outputs the sound at a high volume.
6Adjust the volume of each band in [MIC EQ HIGH] or [MIC EQ LOW] on the [MIXER SETTINGS] screen.
Touch to adjust the volume of sound input from the [MIC] terminal.
Each setting adjusts in the following range.
— [HIGH]: -12 dB to +12 dB (10 kHz)
— [LOW]: -12 dB to +12 dB (100 Hz)
7Speak into the microphone.